Flat/Small Gift Box with four way bow. A great gift box for a pandora charm box, or other small gift. While I've designed this gift box around a pandora charm box it can be used for other small gifts. An evolution to my original gift box i wanted to make a gift box with 4 ribbons. and a bow. Ive achieved this with multiple parts and therefore requires assembly. while you don't necessarily need glue i would add a small amount if you feel it needs it. Assembly is straight forward, insert the base in to the base ribbon. being carful as the ribbon is delicate. if you do bent to far you may find it sticks out just a little. this is easily fixable with just a touch of heat and hold in place so its straight against the main box. The same with the lid and top ribbon. this is less likely to bend as its shorter. the small connecting piece goes through the lid, the ribbon and the bow clips on to the connecting piece. again be carful, the connecting may be a little tight depending on your printer tolerances. but it should clip into place. The lid and base of the main box does require supports. set supports to normal auto for these two objects only and set top z distance to 0.3. the ribbons do not require any supports. Please make sure all parts are printed on the same printer. if you print the boxes on one and the ribbons on another they may not fit correctly. I tried to do this with 2 A1's and the parts did not fit together. lastly... choose you filaments wisely. if found in testing silks do not come out as well as normal pla or sparkle. i mean it prints fine just not quite as good quality. and silk can be more brittle than pla. Bambu metal filaments again no quite as good of a finish as the bambu sparkle. I suggest printing a couple of pieces as a test first in your chosen filament. 0.2 layer height. 10-15% infill.