This military weapon crate inspired hinged and latched gift box is perfect for gifting or selling any and all of my Keychain Blasters!
It comes with an insert for each Keychain Blaster I've released (and I will be adding one for each I release) that has appropriate slots for ammunition and key ring.
It also works nicely without the insert for all kinds of small bits and bobs!
Printing tips:
No supports needed. All parts are oriented optimally in the files.
I recommend printing the latches slow and steady with "precise walls" enabled to make sure the filament holes are not too small.
Use low layer height or adaptive/variable layer height for the lid to minimize layer visibility on the sloped parts of the lid bars.
You can print the inserts with low percentage Lightning infill to save time and material.
If you use Bambu Studio or OrcaSlicer, a handy print project file is included!
Assembly:
Use a piece of 1.75mm filament as pins for the hinges in the lid and latches, as well as for the catch bar for the latches. Use a drop of superglue at the ends. See the project article in the Projects section of this page for example pictures.
Then glue the corner deco plates onto the crate corners and you're done.
If you enjoy my designs and want to sell prints of them, I have membership tiers with commercial license available! Also if you want to support me while getting access to all my premium designs, I have a cheap personal tier. Please check out my membership plans! ❤
