Nick B

Desk Edge Cable Holder (Print upright, no supports)

by
xelu
Follow
Follow
Remix Model
xelu
xelu
|
Image 1 of 8
Desk Edge Cable Holder (Print upright, no supports) 3d model
xelu
xelu
|
Image 1 of 8
Desk Edge Cable Holder (Print upright, no supports) 3d model
xelu
xelu
|
Image 1 of 8
Desk Edge Cable Holder (Print upright, no supports) 3d model
2D
3D
Makes
Desk Edge Cable Holder (Print upright, no supports) 3d model
Desk Edge Cable Holder (Print upright, no supports) 3d model
Desk Edge Cable Holder (Print upright, no supports) 3d model
Desk Edge Cable Holder (Print upright, no supports) 3d model
Desk Edge Cable Holder (Print upright, no supports) 3d model
Desk Edge Cable Holder (Print upright, no supports) - Orca Slicer
- Crosshatch infill
- Ironing on all top surfaces
- Precise wall and z-height

Printed as expected, no issues with spinning the collars. Printed in ~45 minutes with ~22g of filament. - 3d model
Desk Edge Cable Holder (Print upright, no supports) 3d model
Desk Edge Cable Holder (Print upright, no supports) 3d model

Make sure you print this upright!

A solution to keep your cables on the edge of your desk for easy access while also being able to easily swap them around.

The revolving chamber has gooves for your fingernail to make it easier to spin. The first few spins will take a little force until the layer lines detach and smooth out.

It's designed to grab onto the end of any cable and hold it at an angle above your desk surface so you can easily grab and pull on it.


831 Likes2.2K DownloadsNovember 11, 2024


831 Likes2.2K DownloadsNovember 11, 2024

Instructions

Filament • 0.2mm

MaterialPLA
Layer height0.2 mm
Infill density0 %
SupportsNone
BrimNo