I wasn't happy with the pocket operator stands out there so I designed one that can hold pocket operations with and without the original rubber case

Pocket Operator Stand (with or without case)

Pocket Operator Stand 1U.stl

Make sure you print this upright!

A solution to keep your cables on the edge of your desk for easy access while also being able to easily swap them around.

The revolving chamber has gooves for your fingernail to make it easier to spin. The first few spins will take a little force until the layer lines detach and smooth out.

It's designed to grab onto the end of any cable and hold it at an angle above your desk surface so you can easily grab and pull on it.

Desk Edge Cable Holder (Print upright, no supports)

1 Cable Side Holder.stl

Under Desk Headphone Hook

Under Desk Headphone Hook.stl

Universal Audio Volt 176 Under Desk Mount

UA Under Desk DAC Mount.stl

iFixit Picks Holder

iFixit Picks Holder.stl

I made this only for 14 bits, specifically the most common ones I use: 4x torx, 4x hex, 3x phillips and 3x garbage ones

Angled Hex Bit Holder

Angled Hex Bit Holder.stl

I forgot to add a venting hole at the bottom to prevent the vacuum seal effect, so I strongly recommend you drill a small ~3m-5m hole at the bottom

Dremel Versa Flame

Dremel VersaFlame.stl

Drill Bit Holder (Wood, Metal & Masonry)

Drillbit Gridfinity Metal.stl

LTT Screwdriver (Best for Stubby)

LTT Screwdriver.stl

Parts Bowls

Parts Bowl 1x2.stl

Toolchest Wera Socket Set (Metric)

Toolchest Wera Socket Set.stl

Zyklop Wrench (European Edition)

Zyklop Wrench.stl

Angled Battery Holder for AA and AAA

Angled Battery Holder for AA and AAA.stl

iFixit Spudger and Picks holder

iFixit Spudger and Picks holder.stl

32mm Muji Spray Bottle Holder

32 Muji Spray Bottle.stl

A little clip designed to go under your steering wheel to store your garage rfid card for easy access

Requires double sided tape for mounting

EZ Access Card

EZ_Access_Card_-_No_Tape_Groove.stl

Rod of Justice.stl

An ACTUALLY effective way to cable manage your desk or workshop.

I designed this clip because I wanted to be able to easily put cables into it AND take them out, without undoing any velcros, or ties or any headaches. 

I recommend you place a handful of these every ~20 cm or so under your desk creating a "cable highway"

Requires a single M4 screw

Cable Management Binocular Cable Clip (Actually Fast & Easy)

Binocular_Cable_Clip.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

xelu

Achievements

Explorer

Seedling

Fan Favorite