9mm Ammunition Storage Case

There are two separate Print files, the "9mm lid" and the "9mm case" they can be printed on the same plate or separately.

• Magnets (8x2mm) incorporated into the lid and case give a satisfying "click" when the box is slid shut and do a good job keeping it closed.
• Rounds sit flush in their slots and leave no excess space that allow the rounds to rattle when the case is closed.
• When the lid is removed it is inserted into the slot in the base of the case to push the rounds up for easy access.

Print settings:

• 0 .4mm nozzle
• 0.12 layer thickness in
• Matte PLA
• Print both the case and lid vertically, no supports should be required.
• As satisfying as they are, magnets are not 100% necessary for this print and can be skipped if desired. The case will print fine without them.

Magnet Install:

• The magnets are installed into the case during the printing process.
• When slicing locate the last print layer before the magnet holes are caped(will depend on your layer thickness) and add a pause at that layer.
• For Bambu studio and Orca slicer, this can be done by right-clicking the plus sign (+) on the layer slider on the right side of the preview screen and selecting “Add pause”
• Once the print has paused at the designated layer, drop the magnets in and resume the print.
• Pay close attention to the polarity of the magnets when installing them in the top and case! I suggest testing and marking the side of the magnet you want face down/up.
• Also verify that the magnet wont pop out and stick to your print head… advisably before you start printing…