13 Likes21 DownloadsSeptember 14, 2024
There are two separate Print files, the "9mm lid" and the "9mm case" they can be printed on the same plate or separately.
- Magnets (8x2mm) incorporated into the lid and case give a satisfying "click" when the box is slid shut and do a good job keeping it closed.
- Rounds sit flush in their slots and leave no excess space that allow the rounds to rattle when the case is closed.
- When the lid is removed it is inserted into the slot in the base of the case to push the rounds up for easy access.
Print settings:
- 0 .4mm nozzle
- 0.12 layer thickness in
- Matte PLA
- Print both the case and lid vertically, no supports should be required.
- As satisfying as they are, magnets are not 100% necessary for this print and can be skipped if desired. The case will print fine without them.
Magnet Install:
- The magnets are installed into the case during the printing process.
- When slicing locate the last print layer before the magnet holes are caped(will depend on your layer thickness) and add a pause at that layer.
- For Bambu studio and Orca slicer, this can be done by right-clicking the plus sign (+) on the layer slider on the right side of the preview screen and selecting “Add pause”
- Once the print has paused at the designated layer, drop the magnets in and resume the print.
- Pay close attention to the polarity of the magnets when installing them in the top and case! I suggest testing and marking the side of the magnet you want face down/up.
- Also verify that the magnet wont pop out and stick to your print head… advisably before you start printing…
Categories:
13 Likes21 DownloadsSeptember 14, 2024
13 Likes21 DownloadsSeptember 14, 2024