Vehicle fitment: 2007+ Toyota Tundra with flip-up center seat and console with two cup holders. This fits the front cup holder only.
Special considerations: This DOES NOT fit trucks that have the full length center floor console.
Recommended hardware to sell with printed part:
- (8) #10-24 x 3/4” Phillips head screws
- (8) #10-24 square nuts
With this hardware, a purchaser will be able to mount an AMPS-compatible mount to both the front and top of this block.
Recommended print settings:
- ABS is highly recommended to prevent warping in hot vehicles.
- The "heavier-duty" your parts are, the happier your customers will probably be. I'd recommend printing as close to 100% infill as you're willing to go, especially around the area where this hooks to the cup holder.
- Supports are not recommended for this part.
Installation details to know: No hardware is required to install the printed part on the cup holder. It just gets pressed on and is a compression fit.
Photos: Included when you download the print file for this model is a zip file with photos. There are a couple photos showing the printed part installed and numerous photos showing any components and/or options the customer must have in their vehicle in order for the printed part to be compatible. It's helpful for customers to see photos of these components (consoles, cup holders, etc) so they can double check that it matches what they have in their vehicle. You are welcome to modify and/or use these images in your listings.