Vehicle fitment: 2000-2005 Toyota Tundra with flip-up center seat and console with two cup holders. This fits either of the two cup holders.
Special considerations: This DOES NOT fit trucks that have the full length center floor console.
Recommended hardware to sell with printed part:
- None
Recommended print settings:
- ABS is highly recommended to prevent warping in hot vehicles.
- The "heavier-duty" your parts are, the happier your customers will probably be. I'd recommend printing as close to 100% infill as you're willing to go, especially around the area where this hooks to the cup holder.
- The best way I've found to print these is upside down with tree supports supporting the bottom of the holder. Tree supports help save filament and if configured correctly, provide plenty of support.
Installation details to know: No hardware is required to install the printed part on the cup holder. It just gets pressed on and is a compression fit.
The holder has an inside diameter of 3.75" to fit most mugs of reasonable size. It can also fit standard 1L water bottles such as Nalgene, Hydro Flask, Yeti, and Klean Kanteen.
Photos: Included when you download the print file for this model is a zip file with photos. There are a couple photos showing the printed part installed and numerous photos showing any components and/or options the customer must have in their vehicle in order for the printed part to be compatible. It's helpful for customers to see photos of these components (consoles, cup holders, etc) so they can double check that it matches what they have in their vehicle. You are welcome to modify and/or use these images in your listings.