Diamond Christmas Bell

This is the fourth in my 2022 Christmas bell series. It prints quickly and easily. Use a nice medium toned silky, metallic or multicolored filament to show off the geometry - or use translucent filament to make it glow.

This is based on my closed lattice, spiral and open lattice bells. It's roughly the same size (slightly taller) with a new loop at the top and a new lattice pattern.

Not for commercial use. Please see license agreement.

PRINT SETTINGS

• Walls: 0.4 - 0.8 mm (I used 0.4 mm for the clear bell and added an alternating extra line for the opaque bell)
• Layer Thickness: 0.15 mm recommended. Anything from 0.1 - 0.2 mm should look good.
• Infill: None. Seriously. It doesn't need it. It just adds weight and print time.
• Rafts/Brim: I didn't use either. However, the first layer is just a single width circle, so you may need to add a brim or raft.
• Supports: None. I designed this to print cleanly without them.