tracking pixel
C

Ender 3 Spool Holder with 3 Bearings

by

cbarth3

Follow
Follow
Remix Model
Like
C
cbarth3
Image 1 of 9
Ender 3 Spool Holder with 3 Bearings 3d model
2D
3D
Makes
Ender 3 Spool Holder with 3 Bearings 3d model
Ender 3 Spool Holder with 3 Bearings 3d model
Ender 3 Spool Holder with 3 Bearings 3d model
Ender 3 Spool Holder with 3 Bearings 3d model
Ender 3 Spool Holder with 3 Bearings 3d model
Ender 3 Spool Holder with 3 Bearings 3d model
Ender 3 Spool Holder with 3 Bearings 3d model
Ender 3 Spool Holder with 3 Bearings 3d model
Ender 3 Spool Holder with 3 Bearings 3d model
This model is restricted by licensing terms. 
0 Likes11 DownloadsJuly 24, 2022
This model is restricted by licensing terms. 


Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4494383.

Had issues trying to get a smaller master spool to fit on the original. https://www.thingiverse.com/thing:1738730 I beveled the edges and removed about .25mm from the bottom. I have an Ender 3 Pro which has a slotted nut so used the nut from https://www.thingiverse.com/thing:3502973 (STL included)

Print needs to be placed on its longest side for best print and to reduce the amount of supports. Might try a raft as the support on the threads where a little hard to remove. No supports needed for the beveled edges.

I started using MicroCenter Inland PLA+ and found that the center hole was not solid and was causing issues rotating. Created a small spool insert (54mm x 63mm).

I placed small pieces of newspaper inside to slow the roll down.


0 Likes11 DownloadsJuly 24, 2022




This model is restricted by licensing terms. 
0 Likes11 DownloadsJuly 24, 2022
This model is restricted by licensing terms.