Membership Release Only
Meet Timmy the sweet ghost kitty, all he wants is to hang out and be your friend. He has cute little toe beans and a boopable nose. Won’t you be his friend too?
At full size the magnet hole should accommodate a 40mm x 5 mm magnet, I used two 32mm magnets since that is what I had. They need strong magnets to hold them between the shelving. The magnets are embedded and you will need to add a pause to the Gcode to insert the magnets before the layer that closes the hole. These do not utilize glue and the magnets are inside the print.
I put the magnets on either side of my hand to ensure I put them, correctly, you could also stick them together and mark them with a sharpie. Whatever works best for you.
Printing recommendations:
- .10 to .20 layer height - Adaptive Layer Height is best
- 5% infill is enough, I would not go over 10%
- 3 walls for strength
- Supports are needed for the tail, I did not need supports for the head - you will need to verify that supports are not in the holes for the magnets. I had to paint supports so this would not happen.
- Pause gcode at the layer before the printer seals the magnet hole so that you can add the magnet(s).
- Make sure you have a clean plate and use your stickum of choice.
If you need help, feel free to message me on Discord or here. I will do my best to reply as soon as possible.
Important Please Read: All Rebel Alicorn Designs are protected under Copyright Law. With your purchase, you are given the right to download and print the design for your personal use only. You do NOT have permission to resell, remix, or redistribute the digital files in any way. No alterations to the designs are permitted. Prints of the designs cannot be sold without permission. To sell the PRINTS of Rebel Alicorn Designs, you must obtain authorization by joining the “Legacy Merchant Tier or Merchant Tier” on either Patreon or Thangs.
More designs are coming soon! Check out my socials and give a follow to keep up to date.
Warning: NOT suitable for unsupervised play by children or pets. Small parts can become a choking hazard if broken off due to rough play and broken 3D printed parts can create sharp edges. NOT recommended for children under 3.