This model is restricted by licensing terms.
View license.
5 Likes8 DownloadsSeptember 1, 2024
This model is restricted by licensing terms.
View license.
I made a pencil case that uses TPU as the hinge and closing mechanism! Print Settings
Supports: Yes
Resolution: .2mm
Infill: 15-20%
Filament: Protopasta HTPLA Notes:
Print Settings -.2mm layer height -15-20% infill -3 perimeters -Support on the closing mechanism -Add a pause into the slicer to switch from TPU to PLA.
Categories:
5 Likes8 DownloadsSeptember 1, 2024
This model is restricted by licensing terms.
View license.
5 Likes8 DownloadsSeptember 1, 2024
This model is restricted by licensing terms.
View license.