Springo Skull
253 downloads · 3 years ago · What a spooky Springo!
Print at .15mm layer height and separate spring manually after printing. No
This model is restricted by licensing terms.Â
View license.
What a spooky Springo!
Print at .15mm layer height and separate spring manually after printing. No supports required!
100% infill is recommended. Results vary by slicer, but basically make sure the layers above and below the small Springo gaps are printing solid (Simplify3D recognizes these as top and bottom layers so you can use a lower infill, but Cura won't recognize the layers as top/bottom, and therefor prints infill instead of solid).
You can use a glow-in-the-dark filament like Polymaker Blue Glow PLA for a cool effect!
This is a remix of the "Low Poly Skull" by slavikk on Thingiverse
Springo Skull
253 downloads · 3 years ago in  andÂ
This model is restricted by licensing terms.Â
View license.
EZPZ Pot Spacers // Airflow and Drainage for Plants
EZPZ TPU Cable Clip Collection // Quick, Flexible, Cable Clips
EZPZ Dummy Nail // Damage Free Wall Hanger Collection
EZPZ Wall Hooks Collection // 17 Variations (and counting!)
EZPZ Shelf Hook Collection // Type 1
EZPZ TPU Cable Clip (4mm)
Caliper Undercut Gauge Adaptors
EZPZ Wall Hook // Type A 36mm
EZPZ Small Shelf Hook // Type1
EZPZ Tube to Wall Mount
Moss Dish/Frame for 100mm Chunky Puck Drip Tray
IKEA Bekväm TPU Feet // Floor Protectors + Grip
Sink Brush Hanger // TPU Brush Loop Kitchen Organizer
SHIMMER 03 Planter
SHIMMER 02 Planter
SHIMMER 01 Planter
EZPZ PS5 Controller Wall Mount
Cloud Dish/Frame for 200mm Chunky Puck Drip Tray
Chunky Puck Drip Tray // 200mm
