SteamDeck Clip on Stand

This is an updated version from v1. This version reduces the amount of support needed, and add adjust-ability and long term durability.

The clip-on stand hold the Steam Deck at 2 positions: 60-degree and 120-degree. In addition, it can clip on anywhere along the flat part in the middle of the Steam Deck, but will block some of the air intake/exhaust.

To prevent the clip sliding. Use electrical tape to line the inner-side of the bottom hook (of the clip).

Print guide: Print orientation: As giving in the STLs

• Resolution: 0.2 mm for the clip / 0.1 mm for the stand and spring
• Infill: 40%
• Filament: PETG is recommended, with PLA support interface (if possible)
• Brim: Clip - yes / Stand - no / Spring - no

Buy me a coffee via: Ko-fi: https://ko-fi.com/a_vinny Paypal: https://paypal.me/NVoChinh BuyMeCoffee: https://www.buymeacoffee.com/a_vinny