Gift Box Can Cup Remix of Scalable Round Screw-Top Box

This is a gift box themed can cup with screw on lid that is a remix of the Scalable Round Screw-Top Box by 3dprintbunny

It prints in multiple parts and assembles easily with glue.

Parts included are:

Top Cover Top Cover Ribbon Bow Pin (to connect bow to top ribbon Bottom (can cup) Bottom Ribbon.

I printed mine on my Sovol SV04 using the following parameters:

3 Walls 10% Infill - Cubic Subdivision 30mm/s Initial Layer Speed 80mm/s Wall Speed 120mm/s Inner Wall Speed 120mm/s Support Speed

I used supports under the ribbon slots for the bottom and cover pieces but if your bridging is on point you may not need them. No supports anywhere else.