Upload for Search
Search By Text
Upload for Search
Search By Text
GA

Small Curved Voronoi Lamp Shade

by

EvilGed

Follow
Follow
Like
Small Curved Voronoi Lamp Shade by EvilGed full viewable 3d model
Loading preview...
2 Likes11 DownloadsFebruary 21, 2022


Community Uploads

No photos added yet, be the first to upload a photo!


2 Likes11 DownloadsFebruary 21, 2022

Community Uploads

No photos added yet, be the first to upload a photo!

Smaller voronoi lamp shade with a more curved design than my last and smaller. ~200mm wide x ~100mm tall, 30mm hole for lamp holder. This one has slightly thinner strands and more holes. Like the last one work well with translucent filaments, looks quite cool if you swap filaments a few time throughout the print too. Print out of heat resistant filament (ABS,ASA etc.) or use low wattage LED bulbs so should it be safe with PLA/PETG, i.e. don't be stupid and burn your house down. On a fast printer should print in around 10 hours @0.2, and is a bit more of a overhang retraction test than the thicker one and you need reasonable cooling to stop the edges curling up.




2 Likes11 DownloadsFebruary 21, 2022


Community Uploads

No photos added yet, be the first to upload a photo!


2 Likes11 DownloadsFebruary 21, 2022

Community Uploads

No photos added yet, be the first to upload a photo!