Gingerbread man/person

contains small parts

Ok so this model is a little complicated, So let me explain.

There are 3 versions

Full body gingerbread man

Bitten gingerbread man

And a multi colour single print version

There are a number of plates all containing seperate parts.

The purpose of me doing this was to allow for people who can only print single colour.

Once I completed those I thought it needed an additional stand and then further I added the candy cain.

The arms and legs are flexible and this is where it got complicated.

0.2mm has been my go to across all of my printers. However with this model I found both the A1 and mini were printing differently to the p1s.

Long story short I’ve ended up including two different tolerances.

The p1s version has 0.2mm

And

The A1 version has 0.3mm

So i suggest you do a test print to ascertain what works for your printer.

Also I’ve printed the gingerbread men face down to get the texture of the plate.

Lastly the bar for the stand.

I printed multiple times upright without supports and worked perfectly.

My last couple of prints it was failing upright on the p1s so I added a version that lays flat. Printing this way means the two nubs don’t quite print correctly.

So again see what works for you if you want to print the stand.

I’ve done my best to include all scenarios

I’ve printed 0.2 layer and 15% infill.

Please give me a shout with any issues.