A 20 mm test tube holder for ant colonies. Print in vase mode. Bonus points if you print it in transparent red filament so you don’t bother your ants as much by viewing them.
Note: My printer has the slightest of elephants foot, the tube is a tiny bit loose in the holder up until the stand part. Thanks to the elephants foot slightly shrinking the entrance these are a near perfect fit. YMMV!
0 Likes1 DownloadsOctober 31, 2024
0 Likes1 DownloadsOctober 31, 2024
Instructions
Filament • 0.2mm
MaterialPLA
Layer height0.2 mm
SupportsNone
BrimNo
Vase modeSpiral