A fuzzy critter! I always love seeing hedgehogs curled up in your hand, so I tried to make this one articulate to do the same. This one prints as small as about 4.1 cm at 65%. Prints in place with no supports.
Files included:
- unibody STL (single part printing)
- unibody 3MF (single part multicolor printing)
- multipart STLs (separate part printing and assembly)
- multipart 3MF (multicolor separate part printing and assembly)
Print settings and recommendations:
- 3 walls at 0.4mm nozzle size
- 40-60mm/s outer wall speed recommended
- 15% infill (adaptive cubic, cross hatch, or gyroid)
- no supports, slow down for overhangs enabled
- no brim unless encountering adhesion issues
- PEZ / polyurea plate recommended
- 65% scale tested
Licensing: These model files are for your personal use only. Commercial licensing is available to sell physical prints of all tinymakery designs at patreon.com/tinymakery.
Categories:
3 Likes0 DownloadsOctober 22, 2024