tiny hedgehog

A fuzzy critter! I always love seeing hedgehogs curled up in your hand, so I tried to make this one articulate to do the same. This one prints as small as about 4.1 cm at 65%. Prints in place with no supports.

Files included:

• unibody STL (single part printing)
• unibody 3MF (single part multicolor printing)
• multipart STLs (separate part printing and assembly)
• multipart 3MF (multicolor separate part printing and assembly)

Print settings and recommendations:

• 3 walls at 0.4mm nozzle size
• 40-60mm/s outer wall speed recommended
• 15% infill (adaptive cubic, cross hatch, or gyroid)
• no supports, slow down for overhangs enabled
• no brim unless encountering adhesion issues
• PEZ / polyurea plate recommended
• 65% scale tested

Licensing: These model files are for your personal use only. Commercial licensing is available to sell physical prints of all tinymakery designs at patreon.com/tinymakery.