Technik G

Electronics-Case (SKR+Relay+Buck) New.stp

by
technik.gegg
Follow
Follow
Remix Model
technik.gegg
technik.gegg
|
|
Image 3 of 4
Electronics-Case (SKR+Relay+Buck) New.stp - Printing orientation - 3d model
technik.gegg
technik.gegg
|
|
Image 3 of 4
Electronics-Case (SKR+Relay+Buck) New.stp - Printing orientation - 3d model
2D
3D
Makes
Electronics-Case (SKR+Relay+Buck) New.stp - New housing - 3d model
Electronics-Case (SKR+Relay+Buck) New.stp - Printed model
 - 3d model
Electronics-Case (SKR+Relay+Buck) New.stp - Printing orientation - 3d model
Electronics-Case (SKR+Relay+Buck) New.stp 3d model
This model is restricted by licensing terms. 

Newly designed housing for the SMuFF controller.

This housing keeps the SKR E3 controller (-DIP/V2.0/V1.2), the Velleman VMA 400, Elegoo 4 or SMuFF mini relay board, the LM2596 or SY8205 buck converter and a display (DIY OLED, LeoNerd's OLED Module or FYSETC 12864 Minipanel) all in one place.

Compared to its predecessor it's not as bulky and makes it quite more comfortable to work with. One can put it on a desk (nearby the printer/SMuFF) or mount it to the printer using a gooseneck mount (HAMA fits best).

The display lid has to be printed flat and then bent to meat the upper angle. Right after it has been printed, let the bed cool down, then remove it from the bed, put it down on the bed again and heat up the bed to 5-10 deg. above the glass temperature of the material (60-70 deg. C for PLA, for example). Wait 10 minutes then bend the lower part until the gap closes.

This STEP files comes also with two lid templates for your own display integration.

**Version 2 ** has been modified so that it can take a SMuFF mini relay board instead of the bigger Velleman or Elegoo relay boards and I've added a GoPro mounting bracket as an alternative to the HAMA Gooseneck mount.


2 Likes24 DownloadsOctober 17, 2021


2 Likes24 DownloadsOctober 17, 2021
This model is restricted by licensing terms.