ReVo360 Mod v3 Front.stl

This is a 2 part mod for the Insta360 Twin lens (360 degree) to turn it into a LR SBS VR180 camera such as the EVO. No supports are needed, print the back piece on the flat back with the open part up. Print the front part face down with the clips sticking up. Keep the original screws from the Twin lens to use to screw the lenses into the back part. Also re-use the screws from the ribbon cable plugs. The front should just push fit and then the whole assembly clips onto the camera as if it was a "normal" 360 Lens.