This model is restricted by licensing terms.
View license.
It originates from this other model of mine on Thangs
M2 / 2.5 / 3 / 4 / 5 / 6 / 7 / 8 / 9 / 10 / 11 / 12 on the front with screw holes
On the back there are hex slots to measure M2 - M12 nuts with corresponding size
It could measure screws length from 4 to 70 mm.
How to print (these are my specific Ultimaker Cura settings in 3mf project)
- 0.12 mm layer height
- 1 wall/perimeter count
- 15-20% infill
- slow print speed (50-80 mm/s) and slower speed on initial layers for better adhesion
- support (approx. 1 mm) for overhanging hex nut slots
Categories:
66 Likes219 DownloadsJune 14, 2024
66 Likes219 DownloadsJune 14, 2024
This model is restricted by licensing terms.
View license.