tracking pixel
gazzaladra

Mushroom shelf “Pleurotus Eryngii"

by
gazzaladra
Follow
Follow
Remix Model
gazzaladra
gazzaladra
|
Image 5 of 7
Mushroom shelf “Pleurotus Eryngii" 3d model
gazzaladra
gazzaladra
|
Image 5 of 7
Mushroom shelf “Pleurotus Eryngii" 3d model
2D
3D
Makes
Mushroom shelf “Pleurotus Eryngii" 3d model
Mushroom shelf “Pleurotus Eryngii" 3d model
Mushroom shelf “Pleurotus Eryngii" 3d model
Mushroom shelf “Pleurotus Eryngii" 3d model
Mushroom shelf “Pleurotus Eryngii" 3d model
Mushroom shelf “Pleurotus Eryngii" 3d model
Mushroom shelf “Pleurotus Eryngii" 3d model
This model is restricted by licensing terms. 

An organic shelf that “grows” from your wall. If you need a small shelf for anything you want to make visible every day (like your favorite Benchy or a small plant) this is the one for you. This one is based on four 3d scans that I had for dinner afterwards.

Versions

  • Pleurotus_Eryngii_shelf_A and _B: The shelves in the default size
  • Pleurotus_Eryngii _shelf_no_holder_A and _B: The shelves without the cut-out intended for scaling down – must be mounted with glue or tape.
  • Pleurotus_Eryngii _shelf_small_A and _B: The shelves in the mini version (60% scale)
  • Pleurotus_Eryngii_holder_default: the holder for the default size with a screw-hole diameter of 5.5mm
  • Pleurotus_Eryngii _holder_small: A holder for the mini version – simply scaling down the default version would make the holder unusable
  • Pleurotus_Eryngii _holder_for_upscaling: If you want a huge version, scale up shelf and use this holder – the only difference is the screw-hole size of 3mm that will be usable when scaled.

Instructions Print the shelf and holder You can either screw or glue it onto your wall. There are various glue or tape products for wall fixation out there. I used 3M Tape. Old fashioned screws and dowels are the most reliable fixation. Insert the shelf by moving it horizontally onto the holder until the holder is completely inside the cutout. Then proceed to move the shelf down and the holder locks. Enjoy!

Print settings Required build volume: 190mm x190mm x 110 mm Material usage: 180 g

Material: PLA Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Outer walls: 3 Infill: 15% Build plate adhesion type: none


5 Likes4 DownloadsOctober 31, 2024




5 Likes4 DownloadsOctober 31, 2024
This model is restricted by licensing terms. 

Instructions

Filament • 0.2mm

MaterialPLA
Layer height0.2 mm
Infill density15 %
SupportsNone
BrimNo
Nozzle size0.4 mm