Six Cable Holder.STL

This is a simple cable holder for 6 cables. Pushing the cables is a bit tight but they fight quite smugly. The total length is around 76mm (3"), the width that cables go in is 7.8mm (0.3") and the corridor that the cable goes through is around 2.7mm (0.1"). This model is similar to other ones I have seen on the database but I made this model from scratch. Attached is the gcode that uses the adaptive cubic infill and is set the bed of 60 degrees and the nozzle to 210, also attached is a STL file and solidworks file for the model.

This is one of my first models so any feedback would be nice :)