Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3715814.
Hi all,
This thing is an enclosure to hold a Duet Wifi with DUEX2/5, an SSR and an ATX PSU.
Current revision runs cables for printer out circular holes. May revise to use connectors.
1.5mm standoffs are required between the duex and tuet wifi for the holes at the back to line up.
Walls are 4mm thick, screws needed for mounting Duets and lid are M4 with length of your choosing (within limitations of thread depth). I have made the thread depths longer than required intentionally to allow for multiple lengths based on availability of different lengths in different areas. The fan and ATX psu mounting points use screw holes based on templates sources via google and I believe are fairly accurate.
Note: A print bed or print height of close to 300mm is required to print this enclosure. Overall dimensions: 289 x 158 x 160. No feet have been designed into the model for it will depend on which way up users wish to use this. Also, I plan to make some feet as a separate piece to fit under the psu ventilation side to allow for ventilation. Why? Making it one piece will make this model even more complex to print.
UPDATE: I have uploaded a new version with a slide in mount for the Duetwifi+duex boards. This has not been printed yet so proceed with caution. It has been designed in Fusion 360 with fairly tight tolerances.
Please comment if you have any questions, and hit like if you use the design.