Window Watt

This lamp is designed to hold a 4 inch (10 cm) solar replacement light. When the solar light (in the on position) is placed in front of a window that gets direct sunlight, the lamp will light at dusk the same as an outdoor solar light.

This links to the solar light I used. The lamp in the photographs was printed on a Bambu Lab1 printer using OVV3D wood filament.

Tree supports were required for the center hole only. It was printed in about 7 hours with a 0.6 nozzle at 0.3 layer height.

The lamp shade is a spiral vase print. It takes about 40 minutes printed at 0.3 layer height with a 0.6 nozzle and 2 bottom layers.