Do you have a Lawnmower 2.0 by Manscaped and want to mount that thang to the dang wall?
I got you!
Print this little guy right here and use either a screw like I did, or some double-sided tape (YMMV) to mount it wherever your little heart desires. You can also mount it on a horizontal surface on the bottom flat face and it'll hold the trimmer up at a sweet 45-ish degree angle, but you'll have to use tape, I didn't put another screwhole for that. I do not recommend using double sided tape on painted drywall, it will probably tear out. Only use double sided tape on strong surfaces like wood or metal
This is for the Lawnmower 2.0. Yes, they are up to 4.0 or something now and my model is nearly 5 years old, but it still works great and I've only replaced the blade once (I do not use it daily, though). This is not an endorsement of Manscaped products.
It may totally work for a Lawnmower 3.0 or 4.0, or other brands. I do not know at all. I can tell you that the opening is approximately 35mm wide by 30mm deep, so you may be able to scale the model and pull it off. Good Luck and let me know if you do, I'll update this description.
This model requires no supports to print.
The trimmer is supported in such a way that the blade does not touch the inside in any place. This model will not dull your blade.
Try not to put it in a place where it will get full of water, I will put drainage holes in version 2.0. You could drill a hole in it if you have to.
If you read this far, please consider giving the model a Like and checking out my other models! Thanks! -Django