DELTA | Pen Holder with divider by CharlesRegaud

This featured model from CharlesRegaud is part of the Thangs Presents! Welcome to 3D Printing: Deluxe Edition membership plan.

If you enjoy this model, be sure to check out other models from CharlesRegaud and follow for more amazing content!

DELTA | Pen Holder with divider

Here is the new addition to our DELTA collection: an adorable pen holder, slightly chubbier than regular pencil cups to allow for more capacity.

The streamlined divider makes sure everything stays upwright in the cup.

Mix and match the colours at will! And have fun printing!

DIMENSIONS | Ø 100mm x H 100 mm

Printing | Cup ~1.5h, Divider ~45min

3D PRINTING SETTINGS

CUP Resolution: 0.2mm / layer or less Build adhesion type: None Supports: None

DIVIDER Resolution: 0.1mm (for smoother finish, but 0.2 can do too) Build adhesion type: 4~6mm brim Supports: None