Summary The wet wipes needed a place so I created this holder fitting to the toilet
paper stand.
It is a two part print and M3 threaded inserts were used to connect them
and also to fastened the holder to the stand.
The holder was printed in PLA.
Print was done with a 0.4mm nozzle, 0.2mm layer height, five outer
perimeters and 10% infill. No supports needed.
Print Settings Printer brand: Prusa
Printer: MINI+
Rafts: No Supports: No Resolution: 0.2 Infill: 10% Filament brand: Prusament
Filament color: black
Filament material: PLA
Category:
3 Likes5 DownloadsApril 5, 2024
3 Likes5 DownloadsApril 5, 2024