Membership Release Only
Meet Drogo the Dragon, he just wants to hang out and be your friend. He has cute little toe beans just like his buddy Timmy. Won’t you be his friend too?
At full size, I put in two 32 mm x 3mm magnets in it. They need strong magnets to hold them between the shelving. The magnets are embedded and you will need to add a pause to the Gcode to insert the magnets at the layer just before the hole is closed. These do not utilize glue and the magnets are inside the print.
I put the magnets on either side of my hand to make sure I put them in the correct way, you could also stick them together and mark them with a sharpie. Whatever works best for you.
Printing recommendations: .10 to .20 layer height - Adaptive Layer Height is best 5% infill is enough, I would not go over 10% 3 walls for strength Supports are needed for both parts.
Pause gcode at the layer before the hole is sealed by the printer, and add the magnet (s) -
If you need help, feel free to message me on Discord or here. I will do my best to reply as soon as possible.
Important Please Read: All Rebel Alicorn Designs are protected under Copyright Law. With your purchase, you are given the right to download and print the design for your personal use only. You do NOT have permission to resell, remix, or redistribute the digital files in any way. No alterations to the designs are permitted. Prints of the designs cannot be sold without permission. To sell the PRINTS of Rebel Alicorn Designs, you must obtain authorization by joining the “Legacy Merchant Tier or Merchant Tier” on either Patreon or Thangs.
More designs are coming soon! Check out my socials and give a follow to keep up to date.
Warning: NOT suitable for unsupervised play by children or pets. Small parts can become a choking hazard if broken off due to rough play and broken 3D printed parts can create sharp edges. NOT recommended for children under 3.