Food Can Dispenser - Stackable FIFO System - 5 can size

Model has been moved to Printables.com:

• https://www.printables.com/model/323945

Organisation freaks: You need it! Preppers: You need it even more!

Couldn't find a proper FIFO (first in first out) system on internet, now there is one !

Design:

• Fully Stackable system
  • Should fit all type of cupboard !
  • Mix/modulate parts as desired

Print:

• @10%
• 2 perimeters
• 0.3layer heights.
• No support

It is strong enough, more would be a waste of time/plastic

Assemble:

• Stack as desired !
• Used some small screws to fix everything together, i'm sure you'll have what what is needed ! I used 10mm_D2.5mm cheap screws on my v2 (check picture for exact measurements)

Available files:

So far I generated all the files for these 5 different can sizes.

CAN_D\CAN_H CAN Height 35mm CAN Height 40mm CAN Height 42mm ** CAN Height 66mm** ** CAN Height 86mm** MIDDLE tubes Feets D54.5mm - - Yes Yes Yes Yes, 6 sizes Yes, 2 types D67.2mm Yes Yes - - - Yes, 6 sizes Yes, 2 types

If you have different diameters/height, message me i'll try to generate the files for you and add them here (try).

Hope it helps !!!

Note:

• It only works for cans that have the same diameter on both side.
• I added some measurement