Food Can Dispenser - Stackable FIFO System - 5 can size
byOlo DeepdelverFollow
Follow
Remix Model
Social
This model is restricted by licensing terms.
View license.
Model has been moved to Printables.com:
Organisation freaks: You need it! Preppers: You need it even more!
Couldn't find a proper FIFO (first in first out) system on internet, now there is one !
Design:
- Fully Stackable system
- Should fit all type of cupboard !
- Mix/modulate parts as desired
Print:
- @10%
- 2 perimeters
- 0.3layer heights.
- No support
It is strong enough, more would be a waste of time/plastic
Assemble:
- Stack as desired !
- Used some small screws to fix everything together, i'm sure you'll have what what is needed ! I used 10mm_D2.5mm cheap screws on my v2 (check picture for exact measurements)
Available files:
So far I generated all the files for these 5 different can sizes.
CAN_D\CAN_H CAN Height 35mm CAN Height 40mm CAN Height 42mm ** CAN Height 66mm** ** CAN Height 86mm** MIDDLE tubes Feets D54.5mm - - Yes Yes Yes Yes, 6 sizes Yes, 2 types D67.2mm Yes Yes - - - Yes, 6 sizes Yes, 2 typesIf you have different diameters/height, message me i'll try to generate the files for you and add them here (try).
Hope it helps !!!
Note:
- It only works for cans that have the same diameter on both side.
- I added some measurement
10 Likes11 DownloadsDecember 2, 2022
10 Likes11 DownloadsDecember 2, 2022
This model is restricted by licensing terms.
View license.