Soap Shower Wall Mount

A light, high strength shelf that lets your soap dry and keeps it from sliding.

Print Recommendations Print Material: PLA

Infill Type: Honeycomb

Infill Percent: 6%

Top Layers: 0 (this is critical to expose the infill and provide draining)

Bottom Layers: 0 (this is critical to expose the infill and provide draining)

Perimeters: 3

Print orientation: Place the top of the soap mount against the build plate

Layer Height: .15 (higher layer heights work just fine, but layers become more visible)

Supports: NONE

Assembly Instructions

Add a strip of waterproof double sided tape to the back of the Soap Mount. The tape recommended below works well on glass, fiberglass, and tile.

Additional Parts Required

Waterproof Tape

• Amazon Link to 3M VHB Tape (https://a.co/d/aACaiWk)