Keychain Attachment for Apple Airtag

A minimalist, snap-in holder for Apple AirTag. Print Recommendations

Print Material: PETG (no other material will work since this model flexes to allow the AirTag to snap into place)

Infill Percent: 20%

Perimeters: 2

Layer Height: .15mm (a layer height greater than .15 will not work well since this model requires a very precise fit)

Supports: NONE

Additional Comments:

The AirTag snaps securely into place but can be removed easily if you need to toss it in your luggage for example. Fits only the official Apple AirTag.