EZPZ Pegboard Hook // 10mm Reinforced Hook

An excellent hook for all your pegboarding needs! This EZPZ pegboard hook prints quickly without supports, and features a unique clipping system that snaps onto your pegboard so it won't accidentally fall out, but it can also be removed in a non-destructive manner!

This particular hook has a 10mm depth and a reinforcing strut along the bottom, which takes up a bit more space in exchange for greater strength. You can check out my other hooks for different sizes, or leave a comment to request something specific!

Printing Guidelines

Print solid. That's it!

The footprint is quite small, so make sure you have a well leveled build plate and good adhesion. You may need to slow down your first layer speed or even add a brim if you're having trouble getting the prints to stay down.

Operating Instructions

These are designed for standard pegboards with 0.25" holes spaced 1" apart, and roughly 0.25" thick.

To install, first insert the top peg, then pop in the bottom clip. You can press the clip from below while inserting if you have a fragile pegboard.

To remove, just to the reverse, pressing from below so the clip can be removed. You can use a flathead screwdriver to press the clip up further, especially if you have a fragile pegboard.