Anycubic Vyper filament holder.

Hi

So I have also made a filament dispenser for Anycubic Vyper. I have designed it for 53mm filament rolls inner diameter.

The insert fits in the Vyper arm. Disassemble the plastic shaft and push this in or turn it so it locks. Depending on if you have done E-Steps tuning it will be loose-tight or fit perfectly. It is made for a 5mm bolt of 100mm (Or use a 5mm threaded rod of 120mm and fit 5mm nuts at both ends. Remember to use the ones with plastic inside so they lock without you over-tightening.

The bearings I have used are standard OD 16mm, ID 5mm, and H 5mm

You can also use a 6mm shaft/6mm bolt, but then you have to drill 6mm in the insert, the wing is prepared for 5mm or 6mm 6mm bearings must be OD 16mm ID 6mm H 5mm

Have fun.