Hi

So I have also made a filament dispenser for Anycubic Vyper. I have designed it for 53mm filament rolls inner diameter.

The insert fits in the Vyper arm. Disassemble the plastic shaft and push this in or turn it so it locks. Depending on if you have done E-Steps tuning it will be loose-tight or fit perfectly. It is made for a 5mm bolt of 100mm (Or use a 5mm threaded rod of 120mm and fit 5mm nuts at both ends. Remember to use the ones with plastic inside so they lock without you over-tightening.

The bearings I have used are standard OD 16mm, ID 5mm, and H 5mm

You can also use a 6mm shaft/6mm bolt, but then you have to drill 6mm in the insert, the wing is prepared for 5mm or 6mm
6mm bearings must be OD 16mm ID 6mm H 5mm

Have fun.


Anycubic Vyper filament holder.

Filament wings for Anycubic Vyper filament holder.stl

For all of you who have made the modification to run with Direct Extruder. Here is a unit that mounts where the extruder used to sit, it has a cable clip that keeps the cable to the print head clear so they don't hit the prints it is making. 

Anycubic Vyper Blend and cable holder.stl

Filament and sensor holder for those who have moved the extruder above the print head for direct extrusion on Anycubing Vyper. This holder has a 4mm hole so the Bowden tube will always be in tension during printing.

Vyper_Filament_Sensor_Holder_for_Direct_Extruder

I was tired of not being able to find my SD and MicroSD cards as well as my tweezers, so here is a file of a Vyper Card & Tool Holder that I made in Fusion360.

Anycubic Vyper SD Card and Tool Holder

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

HB9GIM

Anycubic Vyper filament holder.

Anycubic Vyper Blend and cable holder.stl

Vyper_Filament_Sensor_Holder_for_Direct_Extruder

Anycubic Vyper SD Card and Tool Holder