I designed it for the coming Halloween day. This jack o lantern is very simple, consisting of two parts: the body and the stem. The design is cut out of the eyes, nose and mouth to resemble the real thing. However, the output is somewhat difficult.
※ There is logo on the side ※ ※ The stalk of the transparent face and the cut off face are different. Only one stalk is included. Be sure to check. ※
The assembly method is very simple, just insert the ends of the body pieces one by one on the stem.
One thing to note when printing is that there is a risk that the outer parts will fall off during printing. Therefore, pay attention to bed / plate adhesion. If your bed / plate adhesion is not good, I recommend using Raft.
To insert the LED tea candle inside, pull out three strands of the body, insert the LED tea candle, and insert the remaining body pieces.
LED tea candles are sold in Ikea as GODAFTON, MOGNAD, STOPEN. The size of the LED tea candle is about 40 mm in diameter. Even if it is not a product of IKEA, you can put it inside if it is an LED tea candle. Have a great Halloween day.
When expanded, size = X 137mm, Y 184mm, Z 53mm After folding X 89mm, Y 87mm, Z 82mm
Design by GOODesign