SD Card Storage Camera Lens

This is a spinning SD card holder disguised as a camera lens. It is a great way to store your SD cards, but could also be a great gift for a photographer. These could also sell really well as photographer gifts!

Components you'll need to order. **

1. The Magnets:** 5x3mm Small Round Magnets (Amazon) (same magnets as all other prints)

You'll need 22 magnets per spinner

2. Bearings: Fidget Spinner Bearings (Amazon)

You need just 1 bearing per spinner

Assembly:

The only thing that's different with this spinner than the others is that you need to glue the square thread into the bottom of the lens lid. I separated those two pieces to make it much easier to print, so you don't need a lot of supports. Use superglue, or (ideally) 3D gloop.