SD Card Storage Camera Lens

This is a spinning SD card holder disguised as a camera lens. It is a great way to store your SD cards, but could also be a great gift for a photographer. These could also sell really well as photographer gifts!

Components you'll need to order. **

1. The Magnets:** 5x3mm Small Round Magnets (Amazon) (same magnets as all other prints)

You'll need 22 magnets per spinner

2. Bearings: Fidget Spinner Bearings (Amazon)

You need just 1 bearing per spinner

How to Assemble Assembly Video

The only thing that's different with this spinner than the others is that you need to glue the square thread into the bottom of the lens lid. I separated those two pieces to make it much easier to print, so you don't need a lot of supports. Use superglue, or (ideally) 3D gloop.