4 mm Offset, Command Strip Mount, Cross Quad Offset - DS Part A for Maultiboard

Reduced offset to 4mm and modified to use with a single, Large Command Picture (Velcro) strip - these strips add 4mm, so you end up back to a neat 8mm (less offset results in less lateral loads on the wall mounts)

Print in orientation shown, 0.2mm, 3 walls and 15-25% infill - brim may be helpful (not required on my Bambu P1S). Combined parts weigh ~10.4g

Can be printed flat, while retaining comparable strength, using quality PLA Pro/Plus/etc, using the following - .2mm layers, 4 walls, 35% infill and 'alternate extra wall' if using Orca. Combined parts weight increases by a whopping ~1.5g to ~12g.

Requires a 'low profile' snap removal tool - to be published soon..

Remixed from 8 mm, Cross Quad Offset Snap - DS Part A by Keep Making and inspired by https://than.gs/m/996652 by finntasticg