DIAMOND RIDGES | E27 Lamp Shade & base
This lamp shade was designed to be printed fast, in a couple of hours in vase mode.
Crafted with meticulous attention to detail, the lamp shade boasts a unique, vertical diamond-shaped ridge pattern that casts a mesmerizing play of light and shadows.
SHADE | Ø 280 x H 250 mm | Printing: 2.5h ~ 5h (vase mode)
E27 BASE | W 257mm x L 226mm x H 55 mm | Printing: 1.5h ~ 3h
3D PRINTING SETTINGS
Resolution: 0.2mm / layer or less Build adhesion type: 6~8mm brim Supports: None
The shade must be printed in "vase mode", with bottom and top faces "open". We recommend to set up a brim of minimum 6mm at the base to make sure the shade stays in place during printing.
The base must be printed upside-down, so with the round opening for the E27 socket on the printing bed.
For the shade, it's preferable to use a strong filament, such as ABS or PETG rather than PLA. For the base, any material is fine (except TPU and other rubber-like filaments).