tracking pixel
Corey M

Two-Tier Jewelry Stand

by
CM Design
Follow
Follow
Remix Model
CM Design
CM Design
Image 1 of 3
Two-Tier Jewelry Stand 3d model
2D
3D
Makes
Two-Tier Jewelry Stand 3d model
Two-Tier Jewelry Stand 3d model
Two-Tier Jewelry Stand 3d model
This model is restricted by licensing terms. 
35 Likes61 DownloadsMarch 11, 2022
This model is restricted by licensing terms. 


This simple, yet elegant, jewelry stand has your organization needs covered! The top arm can hold necklaces, bracelets, and rings. The top tray is perfect for holding your earrings and rings. The bottom tray can hold watches, rings, bracelets, and whatever else you may want to place in it!

The print is broken into 5 parts so that you can print it in different colors and without supports! The posts thread together and the arm pressure fits into the hole at the top.

Print Settings I printed the bottom tray at 50% infill to make sure the thread post is ridged. The top tray can be printed with 20% infill.

The posts should be printed at 50% infill to keep it ridged. For the posts a wide brim and slower speeds should be used so that nothing gets nocked over while printing.

Hope you enjoy this print!


35 Likes61 DownloadsMarch 11, 2022




This model is restricted by licensing terms. 
35 Likes61 DownloadsMarch 11, 2022
This model is restricted by licensing terms.