Here is Home Squared game, This super fun design is a 2 to 4 player game that consists of 3 playable characters, a frog, a penguin and Bumble bee, I've also included a spinner and 3 different types of square obstacles such as a blank square, an x piece and a C piece, I've also included a start and a finish block, To assemble the game print off the piece's and line up the game spinner with the base board it should be tight enough to hold in place.
Recommended Game Rules, Each player begins off the board or in the start position, and spins the game spinner, The person with the highest number goes first and so on, the objective is to make it around the board as fast as possible while making sure the other players don't beat you back to the start. The X piece is given to the first player to land on it and can used to slow down other players. Once activated it last for 3 turn's, (you can make this tile effect yourself), Once a player lands on it, they can only get unstuck by rolling a 0 or waiting for 3 turns. If a player does manage to escape on the first try they can pick up the X and replace it on the board, but will lose a turn, If a player escapes the x piece on the 2nd or 3rd attempt then they can move 2 spaces forwards or backwards with that roll and roll normally next turn but the x becomes active for 3 more turns, if the x pieces becomes inactive then flip it over and whoever lands on it gets to activate the tile again. The blank pieces can be used as a skip mean they skip 1-2 spaces forward and can replace the tile anywhere on the board behind themselves Not passing the start tile, if your already on the first tile then it can only be placed underneath you once you move forward, this tile can be useful if your playing in teams of 2 or if your playing more than one rotation I recommend 3-10 rotations, The C Piece can be used as a check point for the next round meaning you can save this tile for yourself and jump to it on your next rotation, but can only be placed on any of the 4 corners making it easier for players to trap you, if all for corners are used then the check point can be placed to remove this tile from the game and the check point takes it's place But the check point then can't be reactivated by you in this rotation, (Flip this tile upside down), The end Tile can be used to end a game quickly mean whoever passes it in what order is their place so 1st 2nd 3rd 4th, Or be used to end a players rotation meaning they must wait at the start tile until every player has passed the start tile, then they gain their roll back after the 3rd player has rolled and played their move. To add to the game if you play in teams you can choose to both move on a roll but will be locked into that the whole game meaning you only roll once, Therefore player A rolls a 6 so player B also rolled a 6 at the exact same time, you take your turn at the same time but with 2 different characters on the board to make this easier in teams you have 2 start tiles on the board example a red start tile and a blue start tile all blue characters start on the opposite side of the board.
Print settings No supports needed for the game board as it's print in place but supports needed for the characters I recommend support type normal, Overhang angle 50% Nozzle size 0.4mm, Layer height 0.2mm, Print speed 100mms, Infill 20%