Snap Open Wall Hangar-Print in Place- No supports.stl

The ultimate way to get organized. I personally use this to hold my gaming controllers and headphones! However, it can be used for much more!!! This prints in one piece and does not need any supports!

IMPORTANT!!! If you are using it to hang controllers or headphones, I would Recommend using screws due to 3M Tape not being strong. Additionally, you have to place the controller in the second divot the one furthest from the wall. Controllers may fall out if there is an earthquake or lots shaking in the room. Just be mindful and while using it.

Instructions: Layer height .16 If you do anything above this you will run into problems. Walls 2. Wall generator classic. If you have it on anything else, you will not get good results. Supports No Brim No

Please share your makes! I would love to see them!