These small and large heart layered fidgets print in place and are very satisfying to play withπ
3D Print Settings: 0.2mm Layer Height PLA works great 15% Infill
Note: The layers of this print are thin (0.8mm), so to ensure a nice first layer, I recommend the following:
- make sure your print plate is clean
- use a smooth print plate
- use a little glue stick on the print plate
- slow the print down for the first couple layers (if I ever have any trouble with first layer adhesion on a print like this, slowing it down usually does the trick π)
Dimensions of Small Heart Layer Fidget: 2 β in. X 2 β in. X β in. Dimensions of Large Heart Layered Fidget: 4 in x 4 in x β in
You could scale up on these but I would caution about scaling down too much because that will make the walls thinner and decrease the spacing between the layers resulting in a less satisfying fidget π
Have fun printing!!
Categories:
1Β Likes4Β DownloadsAugust 14, 2024