These small and large heart layered fidgets print in place and are very satisfying to play with💕

3D Print Settings: 0.2mm Layer Height PLA works great 15% Infill

Note: The layers of this print are thin (0.8mm), so to ensure a nice first layer, I recommend the following:

• make sure your print plate is clean
• use a smooth print plate
• use a little glue stick on the print plate
• slow the print down for the first couple layers (if I ever have any trouble with first layer adhesion on a print like this, slowing it down usually does the trick 😊)

Dimensions of Small Heart Layer Fidget: 2 ⅜ in. X 2 ⅜ in. X ⅞ in. Dimensions of Large Heart Layered Fidget: 4 in x 4 in x ⅞ in

You could scale up on these but I would caution about scaling down too much because that will make the walls thinner and decrease the spacing between the layers resulting in a less satisfying fidget 😞

Have fun printing!!