Adding a new skull to the collection - The Rasta Skull! 💀
The skull requires some supports for the internal jaw parts, don't go to crazy with the amount and avoid creating supports in visible parts (nose, eyes - not required). Added also a 3mf with colored teeth.
Print the Rastas / Braids x 16 times in any color you like - Print one to make sure that it fits and works - Reduce or increase 1% in size if it's not snapping hard enough to the skull or it's too light (You can also use glue if you prefer) and then print the rest.
Although it could be tricky - Try to avoid using a brim to get a nicer and smoother look for the hair. If adhesion is a problem you can use brim and clean up the parts.
** Scaling up should be no problem.
** If Scaling down you will have to make sure the braids don't fuse, they are already pretty tight so scaling it down too much might be a bit tricky in terms of tolerance.
