Rasta Skull
Hey folks!
Adding a new skull to the collection - The Rasta Skull! 💀
The skull requires some supports for the internal jaw parts, don't go to crazy with the amount and avoid creating supports in visible parts (nose, eyes - not required). Added also a 3mf with colored teeth.
Print the Rastas / Braids x 16 times in any color you like - Print one to make sure that it fits and works - Reduce or increase 1% in size if it's not snapping hard enough to the skull or it's too light (You can also use glue if you prefer) and then print the rest.
Although it could be tricky - Try to avoid using a brim to get a nicer and smoother look for the hair. If adhesion is a problem you can use brim and clean up the parts.
** Scaling up should be no problem. ** If Scaling down you will have to make sure the braids don't fuse, they are already pretty tight so scaling it down too much might be a bit tricky in terms of tolerance.
Beerboard
Screaming Cactuses - Part II
Screaming Cactuses - Part I
Bad Easter Bunny
Bunny Flip Stash
Horror Bunnies - The Bunny In The Mask
Horror Bunnies - Ghostface
Horror Bunnies - Jason
Art The Pint
Easter Nightmare
Death By Carrot
Tree Trunk Lamp
Bad Leprechaun
Armored Banana Case
Bad Penguin
Bad Teddy
Till Death Catchall Tray
Ace's Skull
Teddy Bear Ring Box
I can't open step files, just STL
There are no step files for any of my models...
But there's this download option. That's why I claimed.
Sounds good! Ty for your reply. :)
Is it ok to scale this down? If so what % do you recommend?
Hey - You should be able to scale it down a bit but because the Braids are already a bit tight - in terms of tolerance this can be a bit tricky. You can test 1 Braid scaled down and if it works scale down the skull the same size. I'd say 80%-70% should work. Below that you might get some fusion depending on your settings